Error codes
ERR0
Sensor error
Description:
Overspeed, wrong sensor gap or alignment.
Sensor is defect.
Solution:
Press SET button to clear the error.
If the error persists, please contact your vendor.
ERR1
Parity error
Description:
Wrong parity setting.
Solution:
Check your connection parameters.
ERR2
Unknown command
Description:
Command not supported.
ERR3
Sensor overflow
Description:
Sensor measuring range exceeded.
Solution:
Press SET button to clear the error.
ERR4
RS buffer full
Description:
Too many commands have been sent.
Solution:
Change communication speed and/or reduce the amount of commands.
ERR8
Flash access
Description:
Unsuccessful flash access.
Solution:
Press SET button to clear the error.
Switch OFF and ON again the instrument.
If the error persists, please contact your vendor.
ERR9
Flash access critical
Description:
Unsuccessful flash access, critical.
Solution:
Please contact your vendor.
ERR.BT0
Bluetooth® timing error
Description:
Bluetooth® connection parameters outside of recommended values.
Solution:
Try changing Bluetooth® connection parameters (connection interval).
ERR.BT1
General Bluetooth® error
Description:
An undefined error occurred.
Solution:
Switch OFF and ON again the instrument.
Check battery.
ERR.BT2
Bluetooth® initialisation error
Description:
Bluetooth® initialisation failed.
Solution:
Switch OFF and ON again the instrument.
If the error persists, please contact your vendor
ERR.BT4
Internal communication error
Description:
Communication error between microcontroller and Bluetooth® module.
Solution:
Switch OFF and ON again the instrument.
If the error persists, please contact your vendor
ERR.BT5
Bluetooth error, module blocked
Description:
The Bluetooth module has been reset to prevent the instrument from locking up completely.
Solution:
Reconnect the instrument. May require re-pairing (only for Pair and HID profiles)
NO.BT
Bluetooth® communication error
Description:
Bluetooth® module does not respond or is not present.
Solution:
Press any button to use the device without Bluetooth® connection.
NO DATA
Bluetooth® transmission error
Description:
Data transmission failed.
Solution:
Check Bluetooth® connection with master.
------
Starting the Bluetooth module
Description:
The Bluetooth module is starting up
Solution:
This message should disappear automatically:
This message should disappear automatically. Press any button if the message is still displayed after 20 seconds.
